江苏双马的柴油发电机组不仅在国内拥有众多客户，在国外的市场依旧火热。今天小编就给各位中外的客官出一个中英版的柴油发电机使用注意事项。记得为江苏双马打call哦。
检查柴油机供油、润滑、冷却等系统各管路及接头有无漏水、漏油现象；电气线路无破皮等漏电隐患；接地线等电气线路是否有连接松动；机组与基础的连接是否牢固
Check the diesel's pipes and joints of oil supplying, lubricating and cooling system has no phenomenon of water or oil leakage; The hidden perils of creepage with electric lines broken;The electrical lines includes ground wire has no loose connections;The connection generator set and foundation is strong
环境温度低于零度时，须在散热器内添加一定比例的防冻液（具体要求参照柴油机随机资料）
The ambient temperature is lower than zero, must add antifreeze in a certain proportion in the radiator (specific requirements refer to the diesel engine random data)
机组次起动或停用较长时间后再次启动时，应先用手压泵排尽燃油系统内的空气
The first start or stop after a long time to start again,should use hand pressure pump first for exhausting the air in the fuel system
打开电开关，按起动按钮或启动电锁，按下按钮的时间3-5秒，若起动不成功后，应等待2分钟左右，再作尝试。若三次起动不成功，应停止起动，排除电瓶电压或油路等故障因素后，再起动
Turn on the electric switch, press the start button or electric lock, press the button for 3 to 5 seconds。If the start unsuccessful you should be waited for about 2 minutes, try again.If the starting is not successful affter three times, stop the starting and start again excluding out battery voltage or circuits failure factors.
起动时应观察机油压力，若油压无显示或很低时，应立即停机检查
When starting the engine oil pressure should be observed, if the oil pressure showed no or very low, should stop checking immediately.
机组起动后，检查控制箱模块或仪表各项参数：机油压力、水温、电压、频率等。
Generator starting, check control box module or instrument parameters: oil pressure, water temperature, voltage and frequency and so on .
一般情况，机组起动后转速直接达到1500r/min,有怠速要求的机组，有刷发电机怠速的时间一般为3-5分钟，无刷发电机怠速的时间为1分钟左右,怠速时间不要过长，否则可能烧坏发电机组相关元器件。
In general, after starting the generator speed directly to 1500r / min. In accordance with the requirements of idle, brushless generator's idle time is usually 3-5 minutes, without brush generator's idle time for about 1 minute, idle time is not too long, otherwise it may burn the related components.
检查机组油路、水路和气路的渗漏情况，有无漏油、漏水和漏气现象。
Check the Oil Channe, Canalage and Gas Path for leakage if there is leakage phenomenon of oil,water and gas.
注意机组各处的连接和坚固情况，有无松动和剧烈震动。
Pay attention to the connection and strong everywhere, with no loosening and severe vibration.
观察机组各种保护和监视装置是否正常。
Observe various generator protection and monitoring device is normal.
当转速达到额定转速，且空载运行各项参数稳定后，合闸向负载供电。
When the speed reach the rated speed,and after each parameter stable with no-load running,switching power supply to the load
检查确认控制屏各项参数在允许的范围内,再次检查机组的振动,有无三漏以及有无其他故障.
Check the control panel parameters in the allowed range, check again the vibration of the generating set, without leakage of oil water and gas, and any other malfunction.
Need specialist attendant when the generator operation, overload is strictly prohibited!
停机前必须先分闸，一般情况卸载机组需运转3~5分钟后停机
Must first be break-brake before downtime. usually uninstall generator set after 3 ~ 5 minutes running.
发电机组运转出现异常情况时，必须立即停机
When the operation of generator set is abnormal, must stop immediately
紧急停机时，按下急停按钮或将喷油泵停机控制手柄迅速地推到停车位置
In an emergency, press the emergency stop button or push the control handlethe of fuel injection pump downtime to the stop position quickly .
柴油滤芯更换时间为每300小时左右；空气滤芯更换时间为每400小时左右；机油滤芯次更换时间 为50小时，以后为250小时左右。
Diesel filter replacement time is 300 hours; air filter replacement time is 400 hours; the first engine oil filter replacement time is 50 hours, then every 250 hours to replace.
机油次更换时间为50小时，机油正常更换时间为每250小时左右，推荐的机油粘度级别(粘度等级SAE)为15W-40；质量级别(性能等级API,美国石油协会的机油性能分类)详见柴油机说明书及随同资料的要求.注意:粘度级别和质量级别都要符合要求。例如：15W/40CF-4，粘度级别：15W-40质量级别：CF-4。
First time to replace the engine oil after 50 hours,engine oil normal replacement time is about pre 250 hour.Engine oil viscosity level recommended (viscosity SAE grade) is 15w-40;The quality level (Performance Level,API the oil performance classification of American Petroleum Institute) is required to diesel engine specifications and informations.Note: the viscosity grade and quality level to meet the requirements. For example: 15W/40CF-4 viscosity grade: 15W-40 quality level: CF-4.
当打开控制屏时，必须采取必要的防护措施，以防可能发生的触电事故。
When you open the control panel, must take the necessary protective measures to prevent electric shock accidents occured.
不允许随意更改发电机组电路和控制器参数，由此造成的损失和售后服务费用由客户承担。
Not allowed to change the parameters of generator circuit and the controller, the loss and after-sale service fee payed by the customer.
江苏双马机电有限公司是柴油发电机厂家、发电机组厂家，专业生产康明斯、沃尔沃、玉柴等柴油发电机组，发电机厂家欢迎前来选购。
